How many degrees is a saddle bend?
The saddle bend is similar to an offset bend, but in this case the same plane is resumed. It is used most often when another pipe is encountered. Most common is a 45° center bend and two 22-1/2° outer bends, but you can use a 60° center bend and two 30° bends.
How do you calculate a saddle bend?
The steps to making a three bend saddle are:
- Measure the height of the object to be saddled.
- Measure the distance from the end of the conduit to be bent to the center of the object to saddle.
- Place mark on conduit at distance to center of object.
- Add 3/16″ to the distance for each inch of saddle required.
What is the best conduit bending app?
Best Conduit Bending Apps for Android and iPhone
- Conduit Bender Elite™
- QuickBend.
- Electrical Conduit Bender – FREE (Android Only)
- Master Bender Gold – iPhone.
How do you find the center of bend on conduit?
The level or straight edge is then placed along the other side of the bend, similar to the placement for the first line. A second line is then drawn on the conduit along the edge of the level or straight edge. If the bend in the conduit is small, the two lines should cross. This point is the center of the bend.
When making a saddle bend where does your first mark need to be?
To recap: The first bend is made with the conduit mark at the customized “center of 22°” mark you made on the bender. Each of the other bends are made with the conduit mark at the normal arrow used for making a 90° bend with the toe of the bender pointed towards the center mark.
What is a three point saddle bend in Conduit?
The three point saddle bend is a variant of the offset bend since it is an offset bend that returns to the original in-line run after clearing an obstacle. This bend is intended to bridge over obstacles such as existing conduit or plumbing running perpendicular to the intended conduit installation. 1.
What saddle bends can be made in EMT conduit?
He has extensive experience in most areas of the electrical trade. This section of the conduit bending guide will address bending both 3 point and 4 point saddles in EMT conduit (they can also be bent in either IMT or rigid conduit as well using the same procedures). These are the two common saddle bends made in electrical conduit by electricians.
How much bend is needed to bend a 3 Point saddle?
Each piece gets 1 ordinary offset, but the total package is still a saddle. While many electricians will bend a 3 point saddle with a center bend of 45°, a better solution is to make that center bend at only 22° as the total degrees of bend required goes from 90° down to only 45°.
What type of Bender is used to bend conduit?
A hickey bender is used to bend conduit in small bends with short segments, for instance, in order to bend a 90 ° bend with this type of bender you would bend 9 each 10 ° bends with short gaps in betw een them . Another way to bend rigid or IMC conduit by hand is to use a full sweep bender for rigid or use an EMT bender.